Lichee Tang Hex Zynq7020 Fpga Development Board Raspberry Pi Edition Xilinx

• Customization: Available
• Chipset: Zynq7020
• Origin: China
• Model NO.: Tang hex

Product Description

lichee HEX ZYNQ7020 FPGA Development Board Raspberry Pie Edition XILINX ZEDBOARD

Product introduction:

Litchi sugar HEX development board is designed for Xilinx Zynq series of FPGA XC7Z020. It provides a simple and easy-to-use, cheap and easy-to-expand development board for Zynq FPGA users and Zynq FPGA learners.

1.1 main module

1) FPGA: Zynq XC7Z020

2) NAND Flash: 2Gb

3) LPDDR3: 1GB

4) 100M network port: x1

5) USB 2.0: x4

6) TF card slot: x1

2.1 Introduction of main chips:

2.1.1 Main chip: XC7Z020-1CLG484

The Zynq®-7000 SoC family integrates the software programmability of the ARM® processor with the hardware programmability of the FPGA for not only critical analysis and hardware acceleration, but also high CPU, DSP, ASSP and mixed-signal functions on a single device .

This development board uses chip specific features:

PS section:

Cortex-A9, dual core 667MHz,

L1: 32KB instruction space, 32KB data space per core, L2: 512KB, on-chip memory space 256KB.

PL part:

Artix-7 FPGA, programmable logic unit: 85K,

LUTs: 53200, Block RAM: 4.9Mb

2.1.2 Memory Chip: MT41K256M16TW-107

Capacity: 512MB; 32Meg x 16 x8 banks.

DDR3L SDRAM (1.35V), upward compatible 1.5V

2.1.3 NAND FLASH Memory Chip: MT29F2G08ABAEAWP

1) ONFI 1.0 interface standard

2) SLC technology

3) Structure:

Page size x8

2112 bytes (2048+64bytes)

Block size

64 pages (128K + 4K bytes)

Plane size

2 planes x 1024 blocks per plane

Device size

2Gb: 2048 blocks

2.1.4 ULPI Bridge: USB3320C

The USB3320 is a highly integrated, full-featured Hi-Speed USB 2.0 transceiver based on the Microchip ULPI interface.

2.1.5 USB HUB & 10/100 NIC chip: LAN9514-JZX

USB Hub:

1 x upstream USB2.0 PHY, 4 x downstream USB2.0 PHY

Network card:

Integrated MAC and PHY with support for 10BASE-T and 100BASE-TX

3, lychee sugar HAX development board use:

3.1 Routine application

Method 1: Write the BIN binary file to the SD card. Power on loading;

Method 2: The Vivado project compiles the generated .out file and downloads it via JTAG;

Achieve the effect:

The LED light is constantly flashing. The other one is controlled by the button.

The process is as follows:

1) New project under ISE:

2) Instantiation

3) Launch SDK